Sample and Hold

Internal Triangle LFO for sample source. Can be replaced by inputting an external source into the Ext. Osc. In jack.

Internal square wave LFO for sample rate selection. Can be replaced by inputting an external trigger source into the Ext. Clk. In jack. Source is sampled on the negative to positive transition of the clock. Pseudo Random output

Track & Hold / Sample & Hold select switch. Bypasses the internal sample strobe in Track position and allows the source to go directly to the output during the lower clock level. When the clock transitions to a high level, the source voltage present at the time of positive clock transition is "held" at the output until the clock transitions low again. Track and Hold output

Slide allows for a slew or glide to be added between output transition voltages. Slide adds transition glide to output

Clock out allows for the sample clock to be used as a timing sync source to other modules. If an external clock source is present at the Ext Clk in jack, the external clock signal is buffered and present at this jack.